LoRa

  1. Location
  2. Home
  3. Module
  4. LoRa
E610-433T20S 433MHz 100mW/1W Wireless High Speed Link Module
E610-433T20S 433MHz 100mW/1W Wireless High Speed Link Module

E610-433T20S 433MHz 100mW/1W Wireless High Speed Link Module

[Carrier frequency]：410~441MHHz

[Transmission power]： 20dBm

[Communication distance]： 6km

[Air rate]： 0.5~470kbps

[Product size]：16.0*26.0*3.9mm

[Product weight]：2.4g±0.1g

[Introduction]：E610-433TXXS product is a high speed continuous transmission type 433M wireless data transmission module developed by EBYTE, with built-in high performance microcontroller and wireless transceiver chip. It operates in the 410-441MHz frequency band (default 433MHz) and has a transmit power of 20-30dBm.The main function is that the module can perform continuous and uninterrupted transmission at different serial port baud rates when in continuous transmission mode, and the data output delay at the receiving end is low, which is suitable forscenarios requiring fast transmission of large amounts of data, such as: high-speed sensing, mapping and measurement control, remote sensing and positioning, etc.

Wireless 433Mhz high-speed continuous transmission

Low latency and high-speed data transfer

9600 baud rate / 9.6kbps airspeed / 10 bytes

9600 baud rate / 9.6kbps airspeed / 100 bytes

115200 baud rate / 19.2kbps airspeed / 100 bytes

115200 baud rate / 19.2kbps airspeed / 200 bytes

adapted to RS232/485, ModBus, and other bus protocols

suitable for PLC control, and industrial automation control modules.

Time required for the master station

Speed-first strategy, Distance-first strategy

supports up to 470kbps data transmission rate

Support trunk networking

Multiple modes of transmission and diverse networking methods.

Firmware upgradeable

Standing wave pattern

Power and second harmonic diagram

Application scenario

RF parametersUnitPerformanceRemark
E610-433T30SE610-433T20S
Operating frequency bandMHz410-441Global license-free ISM 433MHz band with user-programmable control
Transmitting J powerdBm30.0i0.520.0±0.5User programmable controls
Blockine J powerdBm0 〜10.0Low bum-in probability for close range use
Receivine J SensitivitydBm-123--124Airborne rate of 1.5kbps
Matchine J impedanceQ50IPEX-1 interface antenna matching impedance
Air Ratekbps0.5-470User-programmable control [Note 1]
Measured distancekm2 (continuous transmission mode)1 (continuous transmission mode)Clear and open, height 2m. serial baud rate 115200 [Note 2]
10 (general transmission mode)6 (general transmission mode)Clear and empty, height 2m. air rate 1.5kbps

Note 1: Valid in general transmission mode.
Note 2: In continuous transmission mode, the module automatically calculates and matches the over-the-air
rate by means of the serial port baud rate.


Electrical parametersUnitPerformanceRemark
E610-433T30SE610-433T20S
Operating voltaee JV3.0~ 3.61.8 ~ 3.6>3.3V fbr guaranteed output power, exceeding 3.6V will permanently damage the module
Communicati on levelV3.3Risk of bum-in with 5V TTL
Transmitting currentmA1000125Instantaneous power consumption
Receiving currentmA4038
Sleeping currentuA2.0Software shutdown
Operating temperature℃-40 〜+85Industrial
Storaee J temperature℃-40〜+125Industrial


Hardware parametersUnitDescriptionRemark
E610-433T30SE610-433T20S
Packet lengthbyte55No limit on package length in continuous mode
Cache capacitybyte4096Seen as unlimited capacity in continuous mode
Modulation method-GFSKGaussian frequency shift key modulation
Communicati on interface-UART serial portTTL level
Serial port baud ratebps2400-230400
Packaging method-SMDStamp hole
PA+LNA-YesOnly LANPower amplifier + low noise amplifier
SAW-YesSAW filter
Antenna interface-IPEX-1Equivalent impedance approx. 50 Q
Dimensionsmm40.5*25.0*3.9(±01)16.0*26.0*3.9(i0-l)Length*width*height
Weightg5.2(i0.1)2.4(i01)



E610-433T20S


No.NameDirectionRemark
1NC-Empty feet
2GND-Module ground
3NC-Null pin
4nNESTOutputModule reset pin. low reset
5NC-Empty pin
6NC-Empty Pin
7NC-Empty Pin
8GND-Module Ground
11GND-Module Ground
12ANT-Antenna
13GND-Module Ground
14GND-Module Ground
15GND-Module Ground
16GND-Module Ground
19GND-Module Ground




20MOInput (very weak pull-up)In conjunction with Ml, detennines the 4 modes of operation of the module (not suspended, grounded if not in use)
21MlInput (very weak pull-up)in conjunction with MO. determines the 4 modes of operation of the module (not suspended, grounded if not in use)
22RXDInputTTL serial input, connected to the external TXD output pin.
23TXDOutputTTL serial output, connected to the external RXD input pin.
24AUXOutputUsed to indicate the operating status of the module.
User wake-up external MCU； output low during power-up self^test initialization: (can be suspended)
25vcc-module power supply positive reference, voltage range: 1.8 to 3.6V DC
26GND-Module ground


Populars

home
product
news
contact