LoRa

  1. Location
  2. Home
  3. Module
  4. LoRa
Ebyte E610-433T30S Unlimited high-speed continuous transmission Wireless data transmission module
Ebyte E610-433T30S Unlimited high-speed continuous transmission Wireless data transmission module

Ebyte E610-433T30S Unlimited high-speed continuous transmission Wireless data transmission module

[Carrier frequency]：410~441MHHz

[Transmission power]：30dBm

[Communication distance]：10km

[Air rate]：0.5~470kbps

[Product size]：40.5*25.0*3.9mm

[Product weight]：5.1g±0.1g

[Introduction]：E610-433TXXS product is a high speed continuous transmission type 433M wireless data transmission module developed by EBYTE, with built-in high performance microcontroller and wireless transceiver chip. It operates in the 410-441MHz frequency band (default 433MHz) and has a transmit power of 20-30dBm.

Wireless 433Mhz high-speed continuous transmission

Low latency and high-speed data transfer

9600 baud rate / 9.6kbps airspeed / 10 bytes

9600 baud rate / 9.6kbps airspeed / 100 bytes

115200 baud rate / 19.2kbps airspeed / 100 bytes

115200 baud rate / 19.2kbps airspeed / 200 bytes

adapted to RS232/485, ModBus, and other bus protocols

suitable for PLC control, and industrial automation control modules.

Time required for the master station

Speed-first strategy, Distance-first strategy

supports up to 470kbps data transmission rate

Support trunk networking

Multiple modes of transmission and diverse networking methods.

Firmware upgradeable

Standing wave pattern

Power and second harmonic diagram

Application scenario

Electrical

parameters

Unit  PerformanceRemark
E610-433T30SE610-433T20S
Operating
volta
V
3.0 ~ 3.6
1.8 ~ 3.6≥3.3V for guaranteed output power, exceeding
3.6V will permanently damage the module
Communicati
on level		V3.3Risk of burn-in with 5V TTL
Transmitting currentmA1000
125Instantaneous power consumption
Receiving
current		mA4038-
Sleeping
current		uA2.0Software shutdow
Operating
temperature		°C-40 ~ +85Industrial
Storage
temperature		°C-40 ~ +125Industrial

Hardware
paramete		UnitDescriptionRemark
E610-433T30S E610-433T20S
Packet lengthbyte55No limit on package length in
continuous mode
Cache
capacity		byte4096Seen as unlimited capacity in
continuous mode
Modulation
method		-
GFSKGaussian frequency shift key
modulation
Communicati
on interface		-UART serial portTTL leveL
Serial port
baud rate		bps2400 ~ 230400-
Packaging
method		-SMD
Stamp hole
PA+LNA-YesOnly LANPower amplifier + low noise
amplifier
SAW-YesSAW filter
Antenna
interface		-IPEX-1Equivalent impedance approx. 50 Ω
Dimensionsmm40.5*25.0*3.9(±0.1)16.0*26.0*3.9(±0.1)Length*width*heig
Weightg5.2(±0.1)2.4(±0.1)-



RF
paramete		UnitPerformanceRemark
E610-433T30SE610-433T20S
Operating
frequency
band		MHz410 ~ 441Global license-free ISM 433MHz band with
user-programmable control
Transmitting
power		dBm30.0±0.520.0±0.5User programmable control
Blocking
power		dBm0 ~ 10.0Low burn-in probability for close range use
Receiving
Sensitivity		dBm-120 ~ -123Airborne rate of 1.5kbp
Matching
impedance		Ω50IPEX-1 interface antenna matching impedanc
Air Ratekbps0.5 ~ 470User-programmable control [Note 1]
Measured
distance		km2 (continuous
transmission
mode)		1 (continuous
transmission mode)		Clear and open, height 2m, serial baud rate
115200 [Note 2]
10 (general
transmission
mode)		6 (general
transmission mode)		Clear and empty, height 2m, air rate 1.5kbps

Note 1: Valid in general transmission mode.
Note 2: In continuous transmission mode, the module automatically calculates and matches the over-the-air
rate by means of the serial port baud rate


1
No.   NameDirectionUsage
1GND-
Module ground
2VCC-
Positive reference for module power supply, voltage range: 3.0 to
3.6 V DC
3AUXOutputUsed to indicate module operating status; user wakes up external
MCU and outputs low during power-up self-test initialization;
(can be left hanging)
4TXDOutputTTL serial output, connected to the external RXD input pin
5RXDInputTTL serial output, connected to the external RXD input pin
6M1Input (very
weak pull-u		In conjunction with M0, determines the 4 modes of operation of
the module (not suspended, grounded if not in use)
7M0Input (very
weak pull-u		In conjunction with M1, determines the 4 modes of operation of
the module (not overhead, grounded if not in use)
11ANTOutputAntenna interface (high frequency signal output, 50 Ohm
characteristic impedance
12GND-Fixed ground
13GND-
Fixed ground
14GND-
Fixed ground
18NC-
NC pin, this pin needs to be overhung
19NC-NC pin, this pin needs to be overhung
20NC-NC pin, this pin needs to be overhung
21RESTInputModule reset pin, low level reset
22NC-
NC pin, this pin needs to be overhung
23NC-
NC pin, this pin needs to be overhung
24NC-
NC pin, this pin needs to be overhung


Populars

home
product
news
contact